'Seahan II' : Cairn

TownlandSeahan
CountyDublin
Grid RefO 081 197
GPSO 08128 19710 (5m)
Longitude6° 22' 51.99" W
Latitude53° 13' 0.54" N
ITM east480366
ITM north584435
Nearest TownTallaght (7.7 Km)
OS Sheet56
UTM zone29U
UTM x449041
UTM y5761192

This is a subsite of:

Seahan Hill - Passage Tomb Cemetery
Hide map  (N.B. Google Maps & GPS readings are slightly out of sync - position is approximate)
Show inline map (by Google Maps)

Visit Notes

Saturday, 27th May 2006

This is the largest of the monuments on Seahan and can be seen for miles around. Early reports about the hilltop say that it had a kerb , but this is no longer visible.

The cairn is 25m in diameter and 2m high. An Ordnance Survey trig point stands on top of it. The southern side has little vegetation on it so the cairn material is exposed.

The views from the top of Seahan are simply stunning. There isn't much you can't see from here.

A kerb is a ring of stones placed around the perimeter of a burial mound or cairn. It basically serves the purpose of a retaining wall to keep the cairn or earth in place. Kerbs are usually associated with passage tombs, but do occur on court tombs and wedge tombs too.

Sometimes on passage tombs the stones can bear decoration, such as at Newgrange (County Meath).

A cairn is a large pile of stones, quite often (but not always) containing a burial. Sometimes they have a kerb around the base.

Most cairns are hemi-spherical (like half a football), but the piles of stones used to cover wedge tombs, court tombs and portal tombs are also called cairns. When associated with these types of monument they are not always round, but sometimes rectangular or trapezoidal.

Click Thumbnail to View Full Size Image

__

Like this monument

Marked Sites

Random Gazetteer

A Selection of Other Cairns

About Coordinates Displayed

This is an explanation of (and a bit of a disclaimer for) the coordinates I provide.

Where a GPS figure is given this is the master for all other coordinates. According to my Garmin these are quite accurate.

Where there is no GPS figure the 6 figure grid reference is master for the others. This may not be very accurate as it could have come from the OS maps and could have been read by eye. Consequently, all other cordinates are going to have inaccuracies.

The calculation of Longitude and Latitude uses an algorithm that is not 100% accurate. The long/lat figures are used as a basis for calculating the UTM & ITM coordinates. Consequently, UTM & ITM coordinates are slightly out.

UTM is a global coordinate system - Universal Transverse Mercator - that is at the core of the GPS system.

ITM is the new coordinate system - Irish Transverse Mercator - that is more accurate and more GPS friendly than the Irish Grid Reference system. This will be used on the next generation of Irish OS maps.

Valid CSS Valid HTML
Page loaded from cache: (Generation time: April 22 2018 09:53:32.)
Top of page | Feedback | About this site
© Copyright Tom FourWinds 2001-2018